CUB601K
802.11bgn ,RT3070 ,USB, 1T1R
►Chipset:RT3070
►WiFi-Band:2.4GHz
►Interface:USB 2.0/USB 1.1
►Data Rate:PHY rate of 150 Mbps
►Antenna:External 50 ohm antenna via an I-PEX receptacle
►Security:WEP, WPA, WPA2
►Dimension:40 mm x 18 mm x 6.2(Max) mm
►Support:Support:WinXP/WinVista/Linux
USB Interface
Bointec CUB601K is a WLAN module supporting IEEE 802.11 b/g/n standards with 6-pin connector supporting USB 2.0 interface.This is a low cost compact WLAN module designed in products with embedded system for the wireless connectivity.
Integrated MAC/BBP and RF
This Module is designed to operate in 2.4GHz ISM frequency band, it applies a highly integrated MAC/BBP and RF single chip RT3070 with 150Mbps PHY rate supporting. It fully complies with IEEE802.11n draft 3.0 and IEEE802.11b/g feature.
|
Specification |
|
|
Standard |
IEEE802.11b/g, IEEE 802.11n(1T1R mode) |
|
Bus Interface |
USB 2.0/USB1.1 |
|
USB Interface |
6-pin, 2.0mm pitch male jumper, or 1.0mm pitch connector |
|
Operation Frequency |
USA (FCC): 2.412 GHz~2.462 GHz(channel 1-11) ISM band |
|
Protocols |
802.11b:CCK, QPSK, BPSK, |
|
Security |
WPA,WP2, 64/128/152-bit WEP, WPS |
|
Electronics characteristics |
|
|
Operating Voltage |
5.0 VDC +/- 5% ( or3.3VDV+/- 5% upon special requirement) |
|
Antenna Type |
External 50 ohm antenna via an I-PEX receptacle |
|
Operating Temperature |
-20ºC to +70ºC |
|
Storage Temperature |
-30ºC to +85ºC |
|
Operating Humidity |
20% to 80% |
|
Storage Humidity |
20% to 80% |
| Certifications | |
| China | (Pending) |
| Canada | IC |
| USA | FCC |
| Japan | (Pending) |
| Taiwan | (Pending) |
| Europe | CE |
